If it's not supposed to be "the brightest"

With the new brightness module VY000007 from ipf electronic can be used to vary the brightness of particularly bright LED lights such as workplace and machine lights.

The VY000007 is the further development of the previous VY000006. While the housing of this module had to be normally closed (nc) for mounting, the mounting holes of the VY000007 are on the outside, which makes mechanical installation extremely easy. The connector and coupling are now positioned on one side. The toggle switch (for switching on and off) and the potentiometer are located on the facing side. This allows installation under a workbench or at a mounting location, for example.

The brightness module VY000007 is operated with a voltage of 24V diagnostic coverage and is suitable for a maximum current of 4A. The electrical connection is made via an M12 plug connector. The robust housing is made of polycarbonate and is designed for an ambient temperature of up to a maximum of +40°C. The VY000007 with degree of protection IP40 is intended for indoor use.

For the connection of the voltage supply, a three-wire M12 cable socket (e.g. the VK200025) is used to connect the power supply.

The LED light is connected up with an M12 connection cable (e.g. the VK200F25) directly to the module. Make sure that the connection of the operating voltage of the light is made via PIN 1 of the M12-connector.

After the connection, the LED light can be switched on and off using the toggle switch, whereby the brightness can be individually adjusted via the potentiometer with 270° setting angle.